Trinamic Discussion Groups

[Wieslaw J. Stryjewski]

Hi,

I need information about using I2C with your stepper motors drivers. In particular with TMCM-110-42 module:

1) Where may I buy modules with I2C interface enabled? (It seems rs232 and rs485 are the most popular interfaces.).

2) Where can I buy the “IIC USB2X interface”? I’d like to check the communication with the motor separately using TMCL-IDE program before connecting it to the i2c bus on my device.

3) All other relevant information.

In the current project I settled for RS485 because I was able to buy TMCM110 module with this interface. The cost is two additional IO pins on the microprocessor. I already have other chips communicating with the microprocessor on I2C bus.

Thanks, Wieslaw

[B. Dwersteg (TRINAMIC)]

Purchasing TRINAMIC products:

TRINAMIC products are available at a number of line card distributors as well as catalog distributors.

Line card distributors can provide you with each product.

Catalog distributors typically stock a selected portfolio of TRINAMIC products only, but you may also try to contact them in order to purchase an other product. Most of them have a detailed online catalog.

Please click here to select your favorite distributor.

For the I²C PANdrive, you will have to contact a line card distributor, while USB2X is available also at most catalog distributors.

[Andrew]

Please also check here:
http://www.trinamic.com/ttdg/profile.php?mode=viewprofile&u=136
I am a distributor, and a partner of Trinamic. You can buy through me too. You can also order various services.

For a reason I am not listed on Trinamic Web site. You may reach me only through my profile on this forum.
Write me a private message. For easier communication please provide your e-mail address.
We serve any country world wide by mail order.

We are a Systems Integrator, and supplier of various mechanical, and electronic solutions.
For our custom programming, and other examples check the links in the signature below.
_________________
Distributor of Trinamic
Our TMCM-DLL is here (not free): http://www.trinamic.com/ttdg/viewtopic.php?t=30 | Power supplies: http://www.trinamic.com/ttdg/viewtopic.php?t=394
On request: System integration services, custom programming, mechanics,etc

[chaim]

Andrew, how can I get your software TMCM-DLL ?
I cannot find your contact anywhere.
chaim

hey, I have found Andrew's page on the web:
http://andrewdll.angelfire.com
There he gives his contact, and his offers.