SIO on TMCM-6110

[spajkalnik]

Hello,
I would like to know how to get something out of the outputs. Using the SIO command on TMCM-6110 in direct mode does not gives any result. Measuring the output pins gives me nothing. Is it perhaps a matter of delivering power to the pins with a bridge on the DIGI or VCC?

[Olav Kahlbaum (TRINAMIC)]

All general purpose outputs are open collector outputs, so measuring between the output and ground won't give you any results. For just measuring put a resistor of e.g. 22k between the output and the positive supply voltage.