TMCM-351 I want to use to run CNC ROUTER?

[saleh]

Hello,
Board has a TMCM-351 I want to use to run CNC ROUTER, I do not know that I can do?
What programs can I use the design, such as Mach 3 and Mstrkam
Thank you for helping me,

[saleh]

Perhaps the first question too difficult ...!!!!
This simple question: what are the uses of TMCM-351?

[TRINAMIC_BD]

Hello, the modules are not specifically for CNC applictions - uses are pick and place machines, and general motion control. There are some co-ordinated moves available, which will allow driving 2d or 3d traces, but in a normal application the motors are driven independently, i.e. without the tight coupling required for a multi-dimensional trace. The modules can work stand-alone (after pre-programming) or as a slave to a PC or other controller.

[Olav Kahlbaum (TRINAMIC)]

I think that the CNC software packages you mentioned do not support our modules. But there is one solution available from our partner Mocontronic (http://www.mocontronic.de) that can use some of our modules (please ask them which modules are supported in their current software versions) with e.g. a HPGL interpreter.