TRINAMIC Support Knowledge Base
For quick support, please BROWSE or SEARCH the forum! Please look up the latest manuals before posting.
TMCM-1110 +5 volt for encoder
2 posts
• Page 1 of 1
TMCM-1110 +5 volt for encoder
by bosque » 09 Jun 2012, 02:19
Is there a pin that has +5 volts I use to power a encoder ?
- bosque
- Newbie
- Posts: 1
- Joined: 09 Jun 2012, 02:13
Re: TMCM-1110 +5 volt for encoder
by Olav Kahlbaum (TRINAMIC) » 11 Jun 2012, 08:35
No, the encoder has to be powered externally. The 5V supply on the TMCM-1110 is not strong enough to power other devices.
For questions concening the TMCM-1110 please prefer to use the stepRocker forum, http://www.motioncontrol-community.org.
For questions concening the TMCM-1110 please prefer to use the stepRocker forum, http://www.motioncontrol-community.org.
-
Olav Kahlbaum (TRINAMIC) - Site Admin
- Posts: 3365
- Joined: 11 Aug 2006, 08:02
2 posts
• Page 1 of 1
Return to Modules / Electrical issues
Who is online
Users browsing this forum: No registered users and 1 guest